Data wysylki: 2025-12-03

I WILL COMMISSION THE PRODUCTION OF FLOWER STANDS FROM ALUMINUM SHEET

I&39 m looking to commission flower stands made from aluminum sheet. Drawing: link to the file . DXF and PDF files available from your Cyberbiznes consultant. Specifications below: Self-watering planters, 40cm long, 14cm high, 14cm wide, black/anthracite (e.g. Lechuza - Cube Glossy Triple Planter), for use in a hanging plant stand. Each stand contains 2 such planters. DZW1 - a set of 3 identical hanging plant stands/covers. Each cover is made of 2mm thick aluminum sheet. The front, sides, and back are made of a single piece of sheet metal, with a weld in the center of the back wall. The bottom is welded to the sides. The planter is attached to the wall with screws. The rounding of the right angles of the planter is greater than 3mm. If the planter requires stiffening due to its size, use a 1x1cm profile welded along the edge of the sheet metal on the side not visible from the front. This solution should be confirmed with the architect before construction. The entire planter is powder-coated in RAL 7021. Self-watering planters, 40 cm long, 14 cm high, and 14 cm wide, in black/anthracite (e.g., Lechuza - Cube Glossy Triple Planter), are placed in a hanging planter. A single planter contains 3 such planters. DZW1 - a set of 2 identical hanging planters/planters. Each planter is made of 2 mm thick aluminum sheet. The front, sides, and back are made of a single piece of sheet metal, with a weld in the center of the rear wall. The bottom is welded to the sides. The planter is attached to the wall with screws. The rounding of the right angles of the planter is greater than 3 mm. If the planter requires stiffening due to its size, a 1x1cm profile should be welded along the edge of the sheet metal on the side not visible from the front. This solution should be confirmed with the architect before construction. The entire structure is powder-coated in RAL 7021.

The term search: 7 dni

Correspondence in: polski